[Insolent Minx]

FiveIXZero, did you do anything different from the youtube video that doubleds65 posted earlier in the thread? Thanks for the feedback. I am going to do this today. I just want to make sure I get all the info correct.

Thanks again,
The Minx

 

[Insolent Minx]

Thanks Doubleds65. I will check that out.

The Minx

 

[Insolent Minx]

C0astie31, that is way cool ride you have. I looked at all those photos you posted. There is some dollarz sunk into that machine!

Anyway, looking at the .pdf that TKR Reptiles posted earlier http://www.tundrasolutions.com/forum...alibration.pdf it shows that your complete procedure is the correct one if you follow all the instructions on the calibration.pdf document.

Thanks again for the awesome photos and info.

The Minx

 

[Insolent Minx]

Last night I signed up for a 5 year subscription to ALLDATADIY for $48.95 and looked for the ZPC Initialization document. I found the correct one and it matched the .pdf that TKR Reptiles posted earlier and the C0astie31 talked about also with the fiinal step of disconnecting the battery. The only difference was they wanted you to keep the NAV DVD in the drive if you had one and to wait 90 seconds after you shut the truck off before you disconnect the battery. It had to do with certain systems writing config info back to their chips.

Thanks again guys for all the work everyone did on this.

The Minx