Toyota Tundra Discussion Forum banner

Rear middle sonar

757 Views 5 Replies 4 Participants Last post by  Ditchhooker
K, got my first issue with my new truck. It rained like crazy here for the past two days and am not sure if that caused my problem or not. When I put my truck in reverse the buzzer is on solid and I know that I am not near anything. It must be the center sensors cause the corner ones work as they should on the little litup display.

Anyone have this issue, I tried to search the forum and came up with nothing.

Thanks
Yinzer


Sent from AutoGuide.com Free App
1 - 6 of 6 Posts
Check the sensor lens. Maybe crud blocking it from all the rain.

Sent from my SAMSUNG-SGH-I317 using AutoGuide.Com Free App
  • Like
Reactions: 1
Check the sensor lens. Maybe crud blocking it from all the rain.

Sent from my SAMSUNG-SGH-I317 using AutoGuide.Com Free App
Thanks, I hope it's something that simple. Will try to clean them up in the am.


Sent from AutoGuide.com Free App
Mine has done it since new in 10. Never gave it too much though as it only was an issue in the rain.
  • Like
Reactions: 1
Went away after the truck dried out then came back today in the rain again. I might take a look at the connectors and see if I can silicone them, my lift and lack of mud flaps means a lot of water gets kicked up.


Sent from AutoGuide.com Free App
  • Like
Reactions: 1
I have no lift and mudflaps, and mine do it in the rain I would say 50% of the time. goes away once it is dry. It rains alot here, and I have haven't had any intrusion thru the connector
  • Like
Reactions: 1
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top