Toyota Tundra Discussion Forum banner
1 - 20 of 29 Posts

· Registered
Joined
·
27 Posts
you get the 2 push pins off? take a flat head screw driver ( i put a little tape on the end to keep from scratching the paint) and slowly pry the plastic piece between it and the fender, it should pop, then just pull it straight out. it wont break. try to slowly pull out and use and up and down motion also to make it a little easier
 
  • Like
Reactions: Brad1221

· Registered
Joined
·
573 Posts
open the hood, on the inside by the radiator there will be 2 blastic screw like tabs you have to remove. just pop a flathead and they will come out. the other side is connected just by tabs, so after you remove the two with a flathead, just pull and they will pop out - it takes some force but they will come out.
 
  • Like
Reactions: Brad1221

· Registered
Joined
·
1,894 Posts
there is a bhlm video on youtube..
 
  • Like
Reactions: Brad1221
1 - 20 of 29 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top