Toyota Tundra Discussion Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
13,964 Posts
depending on what ohm subs you are running you will be pushing anywhere from 350rms to 1000 rms (1ohm) the amp itself only has 4ga inputs, so you will either need to run 4ga or 1ga and then drop to 4 using an adapter or a dist block.
You need an install kit none the less... I would just use a 4ga kit imo... Seems to be a fairly efficient amp, calls for a 100 amp fuse if I read correctly. Just you need ofc copper, not the cca crap if you actually plan to push the amp to its fullest possibilities. *not knowing ohm load you will be running...
 
1 - 1 of 1 Posts
Top