Toyota Tundra Discussion Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
So the bds 4.5" lift is ready for install and I run into a snag reading that I need a center bearing drop kit becuase I have a crewmax.I was also told that I need to modify my driveshaft by two to three inches in lenght.I wish BDS would have specified this info upon check out they do for 2wd but nothing as far as 4wd.Anybody else run into this ?.Thank's
 

· Registered
Joined
·
2,506 Posts
Does your rear suspension remain stock and are you using any type of blocks? I had 2" blocks with Icon expansion pack and my driveline got pulled 7\8" out. I replaced the rear leaf spring with OME DAKAR pack and using David's +4" shackles my driveline gap improved big time. It went from 7/8" to 3/8". Or you can use his spacers to push it back in.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top