Toyota Tundra Discussion Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
I just purchased a 1 inch billet lift spacer (1/2 inch thick spacer) to combine with my Bilstein 5100s.
I am looking at using the middle notch on the Bilsteins and the spacer on top.
I am going to go this route instead of using the top notch on the Bilsteins.

I know a bunch of folks have used these types of small spacers or have combined two of the 1/4 inch spacers (which generates the same lift size). I would like to know if the spacer will work with the factory length top plate studs or do I need to get extended length studs?
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top