Toyota Tundra Discussion Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Trying to install my tonneau cover and I can't get my deck rails off because the torx screws won't come out. I've tried spraying it with Blaster BP, using my impact driver drill and manual hand impact driver and this thing won't budge. I have a spray in liner but it looks like they taped it off before spraying. This was all installed when I bought it. Any suggestions?



Sent from my iPhone using Tapatalk
 

·
Registered
Joined
·
14,228 Posts
They are just tight.

I have had my rails off both trucks a few times, and they are literally just super tight. At least mine were.
 

·
Registered
2015 Toyota Tundra SR5 S/C
Joined
·
56 Posts
Just make sure you reapply thread lock if you re install them. if you don't our Bed Twerk will more than likely loosen them up.
 

·
Registered
2015 Toyota Tundra SR5 S/C
Joined
·
56 Posts
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top