Toyota Tundra Discussion Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
3,322 Posts
You can't swap bowls, the output will be out of focus.

Where r u going to get the power for the projectors, if you connect them into the fog light harness then the will go off when you flash your hi beams, you'll have to connect the projectors into the low beam harness or install and hid relay harness.

You can tap the solenoid wires from the projectors into the high beam harness.
Do a fog bypass. I can have low & high beam and fogs all on at the same time.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top