Toyota Tundra Discussion Forum banner

Vsc wont recalibrate !!!

2K views 4 replies 2 participants last post by  Peter Gozinya 
#1 ·
Well after i installed my lift my truck felt sluggish and the brake pedal was real mushy so i tried recalibrating the Vsc sensor like everyone else and i dont think it worked my seat never buzzed i tryed the washer trick then tried recalibrating again and it is still the same !! can anyone shed some light on this i feel like im losing my mind
 
#2 ·
newer models won't have the buzzer. 2011 instructions are here. Follow the steps for using the SST check wire (aka paperclip). Make sure the truck is level and you aren't bouncing around inside of it during the procedure. Shimming the sensor is not necessary.
 
#3 ·
What's the difference with these instructions they look the same to me ??
 
#4 ·
pretty much the same, less the part about the buzzer..
 
#5 ·
Hahaha ok Ill try one last time of not the dealership will just have to do it thank you very much for ur help who knows maybe I'll get luck this time
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top