Toyota Tundra Discussion Forum banner

2euro's Build Log

43K views 126 replies 30 participants last post by  2euro 
#1 · (Edited)
Project PETYETI Build Log

Hello All,
Thought I'd start one of these build logs going forward. I recently bought a 2010 Tundra CrewMax Limited. Used with 31k miles.

Project PETYETI

As she sits




Mods done to it with previous owner are as follows:
- RBP Running Boards
- RBP Exhaust Tip
- FlowMaster Exhaust
- Line-X Spray Bedliner
- BMF Black 20x9 +25 B/S 6.0" Novakane wheels w/295/65/20 Trail Grapplers
- 3/1 Zone leveling kit
- Colored Handle Assy.
- TRD CAI System
- Front window tint
- UniChip (removed as it was causing a CEL)


Mods I've done are as follows:

Exterior
- White Mirror Caps
- White Sport Grille
- Rigid LED Grille
- Factor55 HitchLink 2.0
- BOLT Hitch Lock
- Craven Speed Stubby Antenna
- Optima Red Top
- Custom Front Camera System (With OEM Nav) -

- SwingCase Cover
- SnugTop Aero Sport
- Prinsu Design Studio Low Profile Rack System
- Demello Custom Hidden Winch System
- Smittybilt X20 Winch 10,000lb


Interior
- Blendmount V1 Kit
- Hypertech Speedometer Calibrator
- Custom OTRATTW camera switch for front camera mod
- TRD Shift Knob
- Locker Down Console Safe
- BlackVue DashCam (DR650)

Lighting
- Morimoto Mini D2S w/ 5000k 35w ballasts
- Rigid SR-Series 30 LED Light Bar Combo
- Rigid Dually Fog w/Tundra fog kit.
- Acro 3840 LED Driving Lights

Current Tire
Pro-Comp Extreme MT2
35/12.5/20

And for those that were wondering, I followed Southern4x4's DIY install.
http://www.tundratalk.net/forums/interior-mods/142321-2013-radar-detector-install.html
 
See less See more
1 2
#2 ·
Nice, post up a picture or two of the mods already done and your truck
 
  • Like
Reactions: Surfer J
#10 · (Edited)
As I wait on parts to come in. I had some .40 shell casings laying around. Decided to make me a set of valve stem caps. Turned out pretty good!

This mod literally took me 5 mins to make. Ordinary plastic caps, used a tiny bit of epoxy and slid it into the shell.

.40 shells are a perfect diameter for the plastic caps.



 
#14 ·
Nice looking truck.
 
  • Like
Reactions: Surfer J and 2euro
#17 ·
Morimoto Mini H1s came in this afternoon. Followed the retrofit source videos on how to install the Mini H1. I also kinda followed Joshua32 DIY thread as well. Not bad for my first time. The longest part was actually aligning the light. Aside from that, it was a piece of cake. Going to do the passenger side tomorrow morning. :D









I'll post up stock vs retro and finally when its all complete.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top