Quote:
Originally Posted by Mickey
DEZ it isn't that hard but time consuming if you don't use a hairdryer. I put the side in the sun and wait an hour then start pulling away. When done use gasket/tape remover to get all glue off then wash the area. Then I used a claybar to make it smooth and then a good carnuba wax job on it.
|
Sweet! Thanks Mic! I've done lots of sticker removal in my time on all my bikes and water craft, heres a good way. Get the sticker started from the top (a warm day is a must or low setting on a blow dryer) spray a little WD40 where the sticker meets the paint and slowley start pealing. WD40 breaks down the adheasive and turns it into goo. The goo residue should whipe off with a little more WD. Clean the area with soapy water and wax.
The only thing I'm not sure about is the affects of the WD on our Truck thin skin.
